Mississippi UST Class A B & C Operator Training

Mississippi Underground Storage Tank (UST) Class AB & C Certification

State Requirements
As required by the EPA, all UST operators must be trained by October 13, 2018. After this date, new Class A and B operators must be trained within 30 days of assuming duties. Class C operators must be trained before assuming duties.

Section 1524 of the Federal Energy Policy Act of 2005 required that the state of Alabama declare amendments to the state underground storage tank rules to require each underground storage tank facility have Class A, Class B, and Class C operators.  Class A or Class B operator candidates will need to pass a written exam in order to be certified. The exam assures that underground storage tank system operators possess the necessary knowledge regarding the proper operation of underground storage tank systems. A test is not required for the Class C operator, but those persons must be properly trained.

The Mississippi Underground Storage Tank Regulations (11 Miss. Admin. Code, Pt. 5, Ch. 2) effective August 25, 2011, require that every UST facility shall have a designated and trained UST Compliance Manager and that every manned UST facility shall have a designated and trained UST Operations Clerk on duty at any time petroleum fuel is dispensed. These regulations were enacted to prevent releases and ensure effective responses occur when releases do occur to safeguard the health, safety, and welfare of present and future generations of Mississippians. All facilities must have trained UST Compliance Managers and UST Operation Clerks by August 8, 2012.

Mississippi was granted state program approval (SPA) in 1997.

Retraining Requirements
Rule 3.9 Certification Renewals.
UST Operator certificates must be renewed every two (2) years. Moreover, if UST system is found to be out of compliance or in significant violation of UST regulations by the Mississippi Department of Environmental Quality (MDEQ), the tank owner will be required to ensure the UST Compliance Manager is retrained within 6 months or a new UST Compliance Manager must be selected for the facility.

Voluntary refresher training is encouraged to ensure operator is up-to-date with current regulations and procedures.

References:

• 11 Miss. Admin. Code Pt. 5, Ch. 1 (PDF)
• 11 Miss. Admin. Code Pt. 5, Ch. 2 (PDF)
• 11 Miss. Admin. Code Pt. 5, Ch. 3 (PDF)
• http://www.deq.state.ms.us/MDEQ.nsf/page/UST_OperatorTraining?OpenDocument

UST Course Information

UST Class A/B Course Description
The UST Class A/B operator training course is presented in chapters. Each chapter utilizes multimedia to enrich the learning experience. Each chapter is followed by a quiz. If the student answers a quiz question incorrectly, the quiz feedback redirects the student to the correct course information.

In addition to the quizzes, the UST Class A/B operator training course includes a final exam of 100 questions, 80% of which must be answered correctly in order to print a certificate.

There is not any time restriction to access the course, so students can complete the entire course in a single session (approximately 4 hours plus exam time) or take the course in segments.

UST Class C Course Description
The UST Class C operator training course consists of seven chapters. Each chapter is followed by a short quiz. Once a student has completed all chapters and quizzes, the learner will be directed to print out a course checklist.

The course is instructed through a student orientation tour of a mock facility, where a manager (or Class B Operator) will identify and explain each topic and then mark them off a checklist when completed.  When the checklist has been completed, the student can then print the UST Class C operator certificate.

There is not any time restriction to access the course, so students may take as much time as needed to complete their training

UST Operator A/B Course Outline
The following topics are covered in the UST A/B Operator course:

• Chapter 1:  Operator Overview
  This chapter describes the primary responsibilities of the Class A, Class B, and Class C operator. It also includes the training requirements for each class of operator.
• Chapter 2:  System and Components
  This chapter seeks to raise environmental awareness as well as clearly communicate a fundamental comprehension of UST systems. Components covered include secondary containment, emergency shut-off valves, vapor recovery, tank materials, and piping materials. A download of UST terminology is available here.
• Chapter 3:  Release Detection
  This chapter emphasizes release detection methods. Equipment testing, the analysis of test results, as well as monitoring of the UST system are addressed in this chapter. Release detection methods covered include automatic tank gauging (ATG), inventory control, secondary containment with interstitial monitoring, statistical inventory reconciliation (SIR), manual tank gauging, vacuum monitoring, soil vapor monitoring, groundwater monitoring, and tank tightness testing. Release detection methods for piping, such as electronic and manual line leak detectors, are also discussed.
• Chapter 4:  Release Prevention
  This chapter prompts the trainee to be proactive in preventing spills and releases. It covers the system components that are designed to prevent corrosion, spills, and overfills. These include spill buckets and sumps as well as sacrificial anode and impressed current cathodic systems, overfill protection valves, overfill alarms, and ball float valves. Secondary containment as well as alarms and warnings are covered in this chapter. An EPA Correct Filling Checklist is available for download.
• Chapter 5:  Planning and Response
  The focus of this chapter is preparation for a release and initial response actions. Topics include recognizing warning signs of a leak, maintaining spill kits, knowing the location of the Emergency Stop button, and posting emergency contact information. Critical attention is given to clean-up and release reporting requirements, including sensitive receptor protection and state notification requirements.
• Chapter 6:  Financial Responsibility/Financial Documents
  Owners and operators of petroleum USTs must demonstrate financial responsibility for bodily injury and property damage caused by spill and releases. This chapter covers financial responsibility statutes and financial assurance mechanisms as well as recordkeeping and reporting requirements.
• Chapter 7:  Registration and Installation
  This chapter discusses required documentation and reporting. Topics include tank permits, registration and administrative documents, and UST installation requirements.
• Chapter 8:  Inspection and Closure
  UST testing and inspection requirements are covered in this chapter. Delivery prohibition and temporary and permanent tank closures are also addressed.

UST Operator Class C Course Outline
The following topics are covered in the UST A/B Operator course:

• Chapter 1:  Facility Overview
  This chapter provides a basic overview of the primary components of a typical UST facility. These components include the USTs, manways, spill buckets, fuel dispensers, and dispenser nozzles.
• Chapter 2:  Monitoring
  This chapter emphasizes the components used to monitor a UST facility. Students will learn what an Automatic Tank Gauge (ATG) is and does, how to interpret its alarms and warnings, and what to do in case of an alarm. The role of line leak detectors is also discussed.
• Chapter 3:  Environmental
  In this chapter, students learn about sensitive receptors, or places where a fuel spill may leave the facility and enter the environment. The chapter also introduces students to the spill kit and its contents, and how to use spill kit components to contain spills threatening sensitive receptors like curb breaks and drains.
• Chapter 4:  Fueling Rules
  The focus of this chapter is fuel delivery safety. Students will watch a short video on proper fueling procedures. Students also learn about hazards at the fueling point, including smoking, static electricity, leaving a vehicle unattended while fueling, and leaving a vehicle running while fueling.
• Chapter 5:  Delivery Procedures
  This chapter teaches the student how to supervise a fuel delivery and monitor for problems during a fuel delivery. Additional emphasis is placed on the ATG and on overfill prevention devices like overfill prevention valves and ball float valves. Delivery prohibitions are also addressed.
• Chapter 6:  Safety
  This chapter covers safety information every Class C Operator needs to respond to emergencies. Included here is a video explaining when and how to use a fire extinguisher. The Emergency Stop and All Stop buttons are identified and discussed.
• Chapter 7:  Emergency Situations
  This chapter discusses common emergency situations and proper responses to them, including what to do if a vehicle leaves the facility with the nozzle still in the vehicle’s fuel spout. Managing customer traffic in the event of a spill is also covered. Correct fire extinguisher operation is reviewed.
• Chapter 8:  Final Checklist
  Review and complete the checklist to complete your training

UST Course Completion Certificate
Print a copy of your completion certificate for your employer and records. You may also login and reprint your certificate at any time.

State Contacts

Mississippi was granted state program approval (SPA) in 1997.

UST/LUST Program

Mississippi Department of Environmental Quality
Office of Pollution Control
Groundwater Assessment & Remediation
Underground Storage Tank Branch
101 West Capitol Street
Jackson, MS 39201

Mailing Address:
P.O. Box 10385
Jackson, MS 39289-0385

Phone: 601-961-5282
Fax: 601-961-5093

UST/LUST Program: http://www.deq.state.ms.us/MDEQ.nsf/page/UST_PageHome?OpenDocument

Fund Program

Mississippi Department of Environmental Quality
Groundwater Protection Trust Fund
P.O. Box 10385
Jackson, MS 39289-0385

Phone: 601-961-5282
Fax: 601-961-5093

Fund Program: http://www.deq.state.ms.us/MDEQ.nsf/page/UST_AssessRemediation?OpenDocument#Trust

Federal Resources

EPA Booklet – Musts for USTS
http://www.epa.gov/oust/fedlaws/regs2015-musts.pdf

This booklet describes the 2015 revised federal UST regulation. Many states and territories (referred to as states in this booklet) have state program approval from EPA. In these states, the state’s UST regulation is used in lieu of the federal UST regulation. To find a list of states with state program approval, see http://www.epa.gov/oust/states/spamap.htm.